Příslušenství vývojové sady Programovací kabel, pro použití s: JTAG-HS3, Nástroj Xilinx 410-299 Digilent

JTAG-HS3 FPGA Programming Cable

The JTAG-HS3 programming cable allows high-speed programming/debugging of Xilinx FPGA and SoC devices from a host PC.

Features

• Separate Vref drives JTAG signal voltages
• Vref can be any voltage between +1.8V and +5V
• USB 2.0 HS port drives JTAG bus at up to 30Mbit/sec
• Compatible with Xilinx ISE 14.1 and newer
• Compatible with Xilinx Vivado 2013.3 and newer
• PC connector: MicroUSB
• JTAG connector: 2 x 7-pin 2mm
• Open-drain buffer on pin 14 allows processor reset of Xilinx Zynq platform

Supported Target Devices

• Xilinx FPGAs; Xilinx Zynq-7000; Xilinx CoolRunner™/CoolRunner-II CPLDs; Xilinx Platform Flash ISP configuration PROMs; Selected third-party SPI PROMs; Selected third-party BPI PROMs

Target Devices Not Supported

• Xilinx 9500/9500XL CPLDs; Xilinx 1700 and 18V00 ISP configuration PROMs; Xilinx FPGA eFUSE programming

An FPGA is a semiconductor device consisting of a matrix of Configurable Logic Blocks (CLBs) connected through programmable interconnects. The user determines these interconnections by programming SRAM. A CLB can be simple (AND, OR gates, etc) or complex (a block of RAM). The FPGA allows changes to be made to a design even after the device is soldered into a PCB.

Notes

This cable is not needed for Digilent Xilinx FPGA boards as they have this functionality built-in.

Supplied with

USB cable